add signal (and noise?) into json

[ZeroChaos-]

TR now outputs signal level every three minutes in a big status report. It would be great to add that signal information (and noise if available) into the json. This would allow a much faster tuning as well as the ability to take a longer average across each system.

[bburkett52]

I guess I am really overlooking something so where and how can I see this signal info? Is it setup in the config.json file? Where does it show up?

Thanks for all the work on this program! I've been running the rc5 version and updating as work progresses. I'm only monitoring 1 P25P2 system and all is good!

Regards, ~Bob

On Fri, Feb 16, 2024 at 11:27 AM Zero_Chaos @.***> wrote:

TR now outputs signal level every three minutes in a big status report. It would be great to add that signal information (and noise if available) into the json. This would allow a much faster tuning as well as the ability to take a longer average across each system.

— Reply to this email directly, view it on GitHub https://github.com/robotastic/trunk-recorder/issues/923, or unsubscribe https://github.com/notifications/unsubscribe-auth/AIOUEODWHDZ6SN3J736GNMTYT6CHHAVCNFSM6AAAAABDMJXQJKVHI2DSMVQWIX3LMV43ASLTON2WKOZSGEZTQOJVGM4DEMI . You are receiving this because you are subscribed to this thread.Message ID: @.***>