Just a thank you

[jimothyr]

Thank you very much for this. This is only reason i had a version of windows running!!!

[hugochinchilla]

I also wanted to thank you, it took just a couple of minutes to have the pedals working.

[bzg]

Yes, thank you very much for sharing footswitch!

[saiballo]

thanks!!

[derphilipp]

Thank you very much; This tool is a real time safer;

[hagemt]

Thanks!

[nfedyashev]

Thank you!

[c704710]

Thank you from me and three of my clients.

[tsdh]

Also thanks from me! With the provided windows software which came with the pedals I could only configure ctrl/alt/shift in a way that when you press and hold one pedal and then press another (e.g., for a Ctrl-Alt-shortcut), the first one was automatically released.

After reconfiguring it with footswitch -1m ctrl -2m alt -3m shift all works as expected. Thank you!

[sanbornm]

Thank you so much! You saved me from installing Windows in a VM to configure. I was up and running in 30 seconds on Arch Linux. FYI you can add Bus 002 Device 031: ID 1a86:e026 QinHeng Electronics (2 pedal) to the README as it works.

[fharper]

Thanks a lot! When I received it, I wasn't believing I had to install a Windows VM to set it properly for my needs!

[shervinemami]

Thanks a lot from me too, I've spent hours trying to find special keycodes that I can trigger behaviours in both Linux & my Windows VM using my foot pedal. I think if I hadn't found this Linux tool I would have used the Windows tool and spent way longer than a few hours till finding the right combination of special keycodes!