RaymondH

Results 25 comments of RaymondH

Of note...

Closing due to inactivity

Manual: some issues I encountered on my build

There is no announced release date.

XY Joint Bearing Stack Misalignment Relative to Belt Path

The belt in the CAD is just a reference. Not an accurate depiction

Too thin wall on SB front results in artifacts

@Badnoob-327 @wile-e1

[Manual] Mention that Hall Effect PCB is for legacy support and not in any way an upgrade

I'll bring it up to the team.

[Manual] Mention that Hall Effect PCB is for legacy support and not in any way an upgrade

Our BOM already lists the normal microswitch setup and not any of the PCBs. But these PCBs are included in the manual because they are so common and we get...

Update to QGL locations, no probe offset

What's the issue with leaving the probe points as is?

Consider increasing depth of solder blob relief for the JST in Tap_Upper_PCB CAD from 1mm to 2mm, to reflect actual pin length/needed relief

@Badnoob-327 @tanaes

Cracks on top bolts on [a]tap_center_r6

Hi. Could you please provide what material and color the part was printed in?

SR latch configuration in PAL unsupported: causes mismatch error during analysis

Yep. Actually was just in the middle of working in peeper instead and I have one pin that will go to a stuck state once activated. I'll just have to...