FlySkyI6

FlySkyI6 copied to clipboard

Increase endpoint range

3

Hi, This firmware is awesome but there is only one thing I cant do: is it possible for you to increase the ENDPOINT range? So far I can go up...

batata004

TGY-AVT01 voltage sensor show wrong voltage :-(

1

It shows 5v and should be around 10v. Some hint. Thank you. ver 1.7.6 sorry my mistake sensor only show internal voltage

welon68

The wiring diagram for connecting an FT232 board is incorrect - the RX and TX pins are swapped around. TX is pin 4, and RX is pin 5:  Connecting...

nicole-ashley

hi

10

Hello, FSI6 is not loading, I tried it with the original installation cable. I also tried it with FT232RL card.

oldcityboy

Are there any additional steps needed apart from switching to SBUS in the menu to enable the protocol? I'm using FS-IA6B and it's supposed to support SBUS but when I...

elpiel

Hi , I tried to add some extra menu , but with out luck , what I wanted to do add some extra menu to the flysky fsi 6 to...

hohonorbika