chubby75
chubby75 copied to clipboard
q3k
Linsn RV901T HUB75 LED "Receiver Card" Reverse Engineering
I need help with Colorlight 5A-75E v 6.1 receiver cards. After installing firmware version 5A 11.04.fw via LED upgrade software into Colorlight 5A-75E v 6.1 receiving cards. Receiving cards start...
According to my tests, the pinout has them both swapped around, `B` on the HUB75 connectors is F2 and `D` is E2.
Has the network protocol for sending video to the Colorlight cards been reversed? I'd like to use them to drive some LED panels with a RPi4. I'm aware of this:...
How do I send data/stream to this controller from my c# program?
Wondered how the outputs can be turned into inputs. On the 5a-75B when changing TC74VHC245 direction pin it would probably feed 5V into FPGA? so maybe powering from 3.3V instead...
For RV901T, the I/O direction of some of the 74HC245 buffers can be set by the FPGA on pin F13 (U600-U607, see [Section Buffer](https://github.com/q3k/chubby75/blob/master/rv901t/doc/hardware.md#buffers). But the VDD on U600-U607 is...
5A-75E v8.0?
I’ve just acquired a v8.0 5A-75E board. It’s not mentioned here, and the JTAG (?) connectors are a square now, not a row. Will try to analyse over the next...
Any idea where i can find the datasheet for the ethernet phy **Broadcom B50612D** used on this board?
Anyone tried upgrading the Colorlight 5A-75B RAM from 2 x 1M to higher capacity ?? Thanks
Does anyone have a working SDRAM controller example for the ESMT devices used on V7 hardware? I quickly looked at the 3'rd party LiteX i the repos but it seems...
