Temporarily Isolate to recognize "Shaft Openings'

[Robbo1234]

Sorry, can PyRevit Temporarily Isolate be coded to recognize "Shaft Openings'? Thanks

[jmcouffin]

? ☝️ @Robbo1234 either write something or close the issue

[jmcouffin]

Stale Closing the issue

[Robbo1234]

Hi there,

Can we get PyRivt Isolate to recognize "Shaft Openings'? Refer to the screenshot below. Thanks

[jmcouffin]

have you tried shift+click on the tool?

[Robbo1234]

Yes, the shift+click is not available on the 'PyRevit Isolate' tool but it is available on the 'PyRevit Pick' tool.

On Wed, 1 Feb 2023 at 12:42, Jean-Marc Couffin @.***> wrote:

have you tried shift+click on the tool?

— Reply to this email directly, view it on GitHub https://github.com/eirannejad/pyRevit/issues/1611#issuecomment-1411995934, or unsubscribe https://github.com/notifications/unsubscribe-auth/ACC6Z42TZ47L3CS7NWQLGZ3WVJK2DANCNFSM6AAAAAAQG527FM . You are receiving this because you were mentioned.Message ID: @.***>

[jmcouffin]

the shift+click is not available on the 'PyRevit Isolate' tool but it is available on the 'PyRevit Pick' tool.

It is available on the latest install for sure. https://github.com/eirannejad/pyRevit/tree/master/extensions/pyRevitTools.extension/pyRevit.tab/Selection.panel/select.stack/Isolate.pushbutton

[jmcouffin]

Since November 2020 at worst