pyocd
It takes ~3 seconds for gdb to connect to pyocd (likely windows only)
Hi. When I run
pyocd gdbserver --port 50000 --telnet-port 50001 --target rp2040
then
arm-none-eabi-gdb.exe .\build\templateRP2040.elf
target remote localhost:50000
It can take up to 3 seconds to connect. When I use 127.0.0.1 instead of localhost it is instant.
I looked at wireshark and it seems like my computer is trying to connect to the ipv6 localhost ::1 before giving up and trying ipv4.
I tried editing the hosts file but apparently doesn't work for localhost anymore, I tried editing the local adapter to not use ipv6 and no dice. I'm on windows 10 (10.0.19045.0 Microsoft Windows NT 10.0.19045.0)
When I edit this line in sockets.py it works.
however this breaks 127.0.0.1, so it's debatable whether this would be a good change.
I am using cortex debug vscode extension and thus I can't easily edit cortex debug so it specifies 127.0.0.1 and not localhost.
TLDR: AFAICT the default behavior in windows causes it to take 3 seconds to connect for a debug session.
Hosting on both ipv6 and ipv4 localhost can work too, I can potentially pr this, just would need to test it on linux and perhaps on another device first
Maybe https://github.com/libusb/libusb/pull/1270? If you have a usb devices disabled or not install drivers
