start_persist.sh not working

[kzahel]

I followed your instructions on a pixelbook but got stuck when running start_persist.sh

SeaBIOS (version rel-1.11.0-0-g63451fca13-prebuilt.qemu-project.org)


iPXE (http://ipxe.org) 00:03.0 C980 PCI2.10 PnP PMM+1FF915A0+1FEF15A0 C980



Booting from Hard Disk...

SYSLINUX 6.04 EDD 6.04-pre1 Copyright (C) 1994-2015 H. Peter Anvin et al
WARNING: No configuration file found
boot:

Booting from alpine virtual ISO again to inspect disk (which I formatted as "sys")

Disk /dev/sda: 4096 MB, 4294967296 bytes, 8388608 sectors
522 cylinders, 255 heads, 63 sectors/track
Units: cylinders of 16065 * 512 = 8225280 bytes

Device  Boot StartCHS    EndCHS        StartLBA     EndLBA    Sectors  Size Id Type
/dev/sda1 *  0,32,33     12,223,19         2048     206847     204800  100M 83 Linux
Partition 1 does not end on cylinder boundary
/dev/sda2    12,223,20   138,146,8       206848    2226175    2019328  986M 82 Linux swap
Partition 2 does not end on cylinder boundary
/dev/sda3    138,146,9   522,42,32      2226176    8388607    6162432 3009M 83 Linux
Partition 3 does not end on cylinder boundary

I ran setup script again (and had to fiddle with /etc/resolv.conf a few times...)

I ran it again with lvmsys instead of sys and I was able to boot this time.

Did you get it to work with normal sys partitioning scheme?