Victor comments

Results 656 comments of


                                            Victor

CGG1-M 2022 shows 0,0°C temperature and 0% humidity

So far I have not encountered such a malfunction...

One of my LYWSD03MMC reports 0C temp and 0% humidity after upgrade to v4.7

Ver4.7 is still a Beta version. Not tested on all thermometer options. --- The new version of ver4.7-beta is corrected for the SHT4x sensor. --- Temperature and humidity are calculated...

One of my LYWSD03MMC reports 0C temp and 0% humidity after upgrade to v4.7

Коэффициенты для датчика исправлены. ![image](https://github.com/pvvx/ATC_MiThermometer/assets/12629515/839106ea-07b7-4ff5-8d4e-0283f9c65fe6)

One of my LYWSD03MMC reports 0C temp and 0% humidity after upgrade to v4.7

Add offset to "Zero offset".

Asking for passcode

The PIN code can be reset only by clearing a special area in Flash. Or the clear all Flash and then writing a new firmware.

Asking for passcode

I meant [USBCOMFlashTx](https://pvvx .github.io/ATC_MiThermometer/USBCOMFlashTx.html) 1. Erase All Flash 2. Write to Flash

Asking for passcode

1. The PIN code protects against changes to the thermometer configuration. 2. Using Bindkey with BLE ad encryption protects against substitution.

[MISC] How to use a rechargeable battery

1. It is not advisable to exceed the supply voltage more than 3.6V. 2. LYWSD03MMC were produced in 6 HW versions. LCD and controllers are different: For LYWSD03MMC, the HW...

[MISC] How to use a rechargeable battery

1N4148 BAV99, BAW56, BAV70, ...

Home Assistant and SSD TBW.

> ESP should be in "passive" mode _misses a lot of advertising packets from BLE devices_ > Sorry if the question seems dumb: this only affects the SSD if the...