wireproxy Question about getting started

Hi. At the first start, it gives me this message: interface address subnet should be /32 for IPv4 and /128 for IPv6. How to fix it?

Jan 13 '23 11:01 DHYTFG

Do you mind sending your wireguard / wireproxy config?

Jan 13 '23 20:01 whyvl

Wireguard conf:

[Interface] PrivateKey = mNyqzNAlyK+93****** Address = 10.6.0.3/24 DNS = 10.6.0.1

[Peer] PublicKey = Gj89agY+2Q5b4Q****** PresharedKey = e/y8yhQG7mU****** Endpoint = 87.120******:4129 AllowedIPs = 0.0.0.0/0, ::0/0

Jan 13 '23 21:01 DHYTFG

Change Address = 10.6.0.3/24 to Address = 10.6.0.3/32

Jan 13 '23 22:01 whyvl

Thank you, can you tell me what to do with this?

Handshake did not complete after 5 seconds, retrying (try 2)

Jan 14 '23 09:01 DHYTFG

Thank you, can you tell me what to do with this?

Handshake did not complete after 5 seconds, retrying (try 2)

This means that wireproxy cannot connect to your wireguard peer. Check your keys and endpoints to see if they are correct.

Jan 14 '23 13:01 whyvl

The problem may be that the server is working via udp?

Jan 15 '23 01:01 DHYTFG

The problem may be that the server is working via udp?

Wireguard uses udp only so I'm not sure what you mean.

Jan 15 '23 01:01 whyvl

Ok. How to fix this problem?

socks: Failed to process the request: Failed to send a response: write tcp 127.0.0.1:9652->127.0.0.1:29670: wsasend: The established connection was interrupted by the software on your host computer.

Jan 15 '23 16:01 DHYTFG