puddly

@jallen2281 I use Telegram but I've also setup a [Gitter chatroom](https://gitter.im/casserole-dev/community) that you can sign into with your GitHub account if that's easier.

Thanks for the pictures. I'm seeing only six instances of the start-of-packet byte `E2` in your capture. Did you invert the RX pin when capturing over serial? If you have...

It's not a software tweak, it's something done in firmware or hardware. The serial data sent by the bus can erroneously be interpreted as "normal" serial but it isn't usable...

I've re-written a large portion of the code. Try it out: ```console $ virtualenv -p 3.9 venv $ source venv/bin/activate $ git clone https://github.com/puddly/casserole $ pip install -e ./casserole $...

Thanks for the help! I've been hoping to finish this project for a while but I have no experience with actually designing PCBs so it's been a little hard to...

1. The whole 5V bus with a pull-down level shifting problem is what's really tripping me up with this whole project so could you clarify what you mean by an...

Hmm, I wasn't aware there could be multiple buses on a single RJ45. That does complicate things. The ESP-32 definitely has enough free pins to do simultaneous TX/RX on all...

Thanks for your interest! I've just pushed my attempt at a schematic and an unrouted board to the Git repo under the `board/` folder. It was draw up with a...

> I assume your goal is to minimize losses in power, and I'm curious if you know what the current supply capability from the bus is? I don't, unfortunately. I...

I've re-checked the SkyConnect PCB and all past firmwares. The RTS and CTS pins are correctly hooked up to the CP2102N, I do not believe they are swapped. All known...