Peter Ooms
Peter Ooms
@sebastien247 I presume this reboot loop will continues a few minutes until the MCU (of the PIR) decides to power-off. Perhaps your MQTT-server may have a Retained (last will) message...
@sebastien247 , better try hexmode and consider Teraterm which is more practical for HEX mode/display. Using Putty for serialising microcontrollers is no fun. It appears to me that your babble-fish...
@sebastien247 You're making progress.. well done. Note: I've made a small typo, stage 4) is telling the MCU the esp8266 is connected to Wifi which in turn let Consider also...
@sebastien247 Great, combining things RX+TX: the Tuya communication sequence itself seems to be perfectly OK !!. >> 55 AA 00 05 00 01 00 05 = esp8266 tells MCU it...
Hi @KirkKirk It's been a while to remember things back. My (I have 3) PIR sensors nicely operate under control of my Domotics (openHAB ) using Tasmota Tuya-device mode. You...
Great to read @KirkKirk it was useful. For the template, it is just a (positional) template that could sometimes ease, not really here, tasmota configuration: {"NAME":"**Lenovo PIR**","GPIO":[255,**107**,255,**108**,255,255,0,0,255,255,255,255,255],"FLAG":0,"BASE":**54**} that nice name...
@bit-user I do recognise your issue. It appears to me, yuou're hit by (likely) some kind of flash load protection. Short: Do at least leave the batteries out, the 120secs...
**openhabian-config** is meant to configure the Raspberry Pi (openHABian) platform which in turn will basically setup the rPI environment. See. https://www.openhab.org/docs/installation/openhabian.html I presume, as you can run Karaf and have...
No problem, we all been there. Regarding a mqqt@qnap broker, if not available somewhere in a QNAP (i/pkg) repository, (virtual) APP etcetera ; as one (like me once did &...
> I'm not a maintainer and do not know if your changes would be accepted, but #5836 was OK... not sure why you closed it. Simple answer: I do not...