Ender 5 profile contains incorrect origin offset by default, outputs invalid gcode

[GhostDog98]

When installing the profile for an ender 5 pro using the wizard, we get the following settings for bed:

However, if we then look at the gcode itself:

We see that we now have an out of range movement, for an object that measures exactly 220mm wide. Correcting this offset to 0.0, 0.0, we get the following gcode (give or take some manual placement errors):

This prints successfully a 220mm wide object. The amount of headache this has caused my trying to print full plates for them to fail halfway through has been immense, but I am unsure on how to correct this config error as i could not find anything under "offset" or "origin" in the files, thus my submission as an issue.

[rtyr]

Could you please look at this @pmjdebruijn ?