Allow users to set default quality in Settings

[mrjohnc]

I really love PrusaControl but I print almost always in draft quality (I'm working on an open hardware project where there are lots of prototype prints). It is a pain to realise an hour into a print you forgot to change from 0.15mm layer height to 0.3mm layer height and your print is going to take 6 hours not 3 hours.

Thanks

[prusa3d-bb]

Hello,

thank you for the feedback, our developers will get back to you soon.

Best regards,

Honza Vysušil Customer Support

PRUSA Research +420 222 263 718 +421 220 570 305 188/7a Partyzánská, 17000, Prague shop.prusa3D.com

For simple troubleshooting, please use: http://help.prusa3d.com

--- original message --- On Tue, Jan 16, 2018 at 09:56 pm, [email protected] John Cummings wrote:

I really love PrusaControl but I print almost always in draft quality (I'm working on an open hardware project where there are lots of prototype prints). It is a pain to realise an hour into a print you forgot to change from 0.15mm layer height to 0.3mm layer height and your print is going to take 6 hours not 3 hours.

Thanks

—

You are receiving this because you are subscribed to this thread.

Reply to this email directly, view it on GitHub, or mute the thread. --- end of original message ---

[vitriolix]

👍

[iandouglas]

There's a draft mode in the filament settings, but the software doesn't allow us to access it.