Print can not be restarted after crash is detected

[Sarlochin]

Related to #3860 prusa3d/[Prusa-Firmware]

Printer type - [MK3S] Printer firmware version - [3.11.0-4955]

MMU upgrade - [none] MMU upgrade firmware version - [ [n/a]

SD card or USB/Octoprint -> PrusaLink 0.7.0rc2

Describe the bug When a crash is detected during printing, and the print fails because the maximum number of crashes is exceeded, it is not possible to resume the print. The printer displays the crash detection message and asks if the print should be resumed. If resume print is selected, the LCD goes blank and the print does not resume. On the web interface, the resume print button can be selected as well and is then greyed out. But the print does not resume. After reloading the page, the button can be pressed again.

To Reproduce Crash printer and select resume print from the LCD or the web interface

Expected behavior After a crash has been detected and the cause is resolved by the user, the print should resume when the “resume print” button is selected. The LCD should not go blank.

[ondratu]

Thank you so much for your report.