Prusa-Link
Prusa-Link copied to clipboard
prusa3d
No IP on .7, works fine with .6
Experiencing a No IP, No LAN error with the current .7 release, refreshed with .6 and it works as expected. Printer itself was never moved and no changed to the router
How did you set up the wifi? Did you enable it in the imager, or did you do the boot partition trick with wpa_supplicant.conf?
I’ve noticed something similar, perhaps the same cause or adjacent to this. It has happened twice so far on 0.7rc2. I start up a large print overnight everything prints but when I wake up it will be completely disconnected. It shows as offline on prusa connect web interface and the state of the print is listed as unknown. I haven’t checked the local web interface though so can’t speak to that.
The only workaround I have found is to fully power cycle the printer.
Similar to OP, I don’t recall seeing anything like this with 0.6. Hope this helps and please let me know if I can help with any additional information.
IIRC it still did, but much less frequently. I could be remembering wrong. I can report back as we get into fall and my printing frequency goes up.
Context: During the summer I don't print as much due to the heat and I turn it off when not in use. This use pattern always hid the issue quite well.
Okay, please report. I tested the PR mentioned and it stopped the apostrophe issue. So I kinda want to close this
Hi, I noticed this morning that it says "No LAN access" which is assume is the same error. It has maybe been running for around 48 hours at this point.
Coincidentally, Prusa Connect is also under maintenance so while I don't think it is related I wanted to mention it in case.