Original-Prusa-i3
Original-Prusa-i3 copied to clipboard
prusa3d
MK3, extruder fan part, append hook on the right side
Sometimes it happens that the cooling part does not fit straight, adding a little hook on the richt site to clip it on will help supporting it to be straight.
(already working on this, will soon make PR)
Hello,
Do you have an order number and a picture of the issue, please?
Best regards,
— Marina Curzi Customer Support
PRUSA Research +420 222 263 718 +421 220 570 305 188/7a Partyzánská, 17000, Prague shop.prusa3D.com
For simple troubleshooting, please use: http://help.prusa3d.com
Please rate our reply ...be generous :-)
--- original message --- On Sat, Oct 27, 2018 at 12:47 pm, [email protected] Marius van Witzenburg wrote:
Sometimes it happens that the cooling part does not fit straight, adding a little hook on the richt site to clip it on will help supporting it to be straight.
(already working on this, will soon make PR)
—
You are receiving this because you are subscribed to this thread.
Reply to this email directly, view it on GitHub, or mute the thread. --- end of original message ---
Hello Marina,
It is not a problem caused with the ordered parts, it occurs when printing your own parts. Since the right side (left in the picture) has no attaching to the extruder body it "hangs" a bit more. When you look closely you see that it is slightly not at te same level compared to both sides.
Adding a little "hook" to the fan part will force it to stay in place, you still have one bolt on the left side to lock it in place.
You can see my idea more as an upgrade than as a problem.
Almost finished the change so I will be adding a pull request referring to this issue soon.
-Marius
Hello,
Thank you for your email. Unfortunately I could not open the picture.
Best regards,
— Marina Curzi Customer Support
PRUSA Research +420 222 263 718 +421 220 570 305 188/7a Partyzánská, 17000, Prague shop.prusa3D.com
For simple troubleshooting, please use: http://help.prusa3d.com
Please rate our reply ...be generous :-)
--- original message --- On Mon, Oct 29, 2018 at 08:29 pm, [email protected] Marius van Witzenburg wrote:
Hello Marina,
It is not a problem caused with the ordered parts, it occurs when printing your own parts.
Since the right side (left in the picture) has no attaching to the extruder body it "hangs" a bit more.
When you look closely you see that it is slightly not at te same level compared to both sides.
Adding a little "hook" to the fan part will force it to stay in place, you still have one bolt on the left side to lock it in place.
You can see my idea more as an upgrade than as a problem.
Almost finished the change so I will be adding a pull request referring to this issue soon.
-Marius
—
You are receiving this because you commented.
Reply to this email directly, view it on GitHub, or mute the thread. --- end of original message ---
I believe what @mariusvw is saying is that because the parts cooler nozzle is only screwed in with one screw, and that screw is only on one side, the parts cooler tends to hang a little at an angle. I've also seen this on my setup with the new extruder.
@prusa3d-bb what @rrauenza describes is exactly what I am trying to say.
I almost finished an upgrade for this on the SCAD files, will make a PR.