Original-Prusa-MINI
Original-Prusa-MINI copied to clipboard
prusa3d
Prusa Mini+ Z-top R1.1 - Extra Height
Based on 3d file uploaded to PRUSA Printers, https://www.printables.com/model/202467-prusa-mini-z-top-r11-extra-height and https://www.printables.com/model/179537-prusa-mini-z-axis-extra-height-adaptor
There is an issue that the extruder assembly owls on the Z axis top.
This in turn is not the true end stop of the PRUSA MINI+.
By removing material of the z top to allow the extruder to pass through, this in turn allows the prusa mini to gain an additional ~4-5mm in z height.
Hello! Thank you for your feedback. If I understood correctly, the issue was only with the parts in the link, but these are not our original parts - our original MINI/+ printable parts are in this folder: https://www.printables.com/model/57214-mini-printable-parts, would the issue be there also with our original parts?
Let me know, in case of anything to further review, do not hesitate to ask.
Alessandro Pantaleo Prusa Research
Hi there, yes, the issue is with the original parts, the Z top will need to be trimmed as per the link attached R1.1. I can provide the step file or any additional clarity as required,
Hello, thank you for the update. I'll review this with devs, thank you. So with this new piece, you can print an object high up to 185mm, instead of up to 180mm, right?
Alessandro Pantaleo Prusa Research
Hi there,
That is correct, a minimum of 5mm additional z axis height is achieved
Thank you for the confirmation! OK, tagged it as enhancement, no guarantees it would be implemented, and likely it won't, but will be there for devs to further review in case. Thank you once again for the suggestion.
Alessandro Pantaleo Prusa Research