MM-control-01 icon indicating copy to clipboard operation
MM-control-01 copied to clipboard

Published 20 hours ago • verified publisher icon prusa3d

Speed Settings Reset Issue

Open Hadeshoof opened this issue 6 years ago • 2 comments

I am very irritated to report that this new firmware does not address the fact that, upon filament change, the speed setting is reset to 100%, ignoring what was entered in Slic3r. Since I use PETG, 200mm speed causes every single print to fail. How is this not addressed yet???

Hadeshoof avatar Dec 19 '18 02:12 Hadeshoof

Which firmware version are you using?

FaultyLine avatar Mar 05 '19 06:03 FaultyLine

Don't forget that if there's any TPU in your print, speed gets set to 35% each time it's loaded, and stays that way.

I've posted >5 times about this, forums, tech support, github. HA HA they have your money. Mine too. :-(

AbeFM avatar Jul 18 '19 22:07 AbeFM