klipper_z_calibration icon indicating copy to clipboard operation
klipper_z_calibration copied to clipboard

Published 20 hours ago • verified publisher icon protoloft

Issue switching build plates

Open ksummers92 opened this issue 1 year ago • 11 comments

I have set up autoZ against a smooth Wham Bam PEX sheet on my Enderwire and it works perfectly. However, when I switch to a textured sheet, the offset is always around -0.38 which results in a first layer as shown in the image below.

IMG_1006

My understanding is that the autoZ should accommodate for build sheet changes and there is even mention of potentially manually adjusting closer for textured sheets. However, my experience thus far has been that I need to adjust the offset up by as much as 0.4.

Am I missing something?

ksummers92 avatar Jul 15 '23 17:07 ksummers92