hs-probe
hs-probe copied to clipboard
probe-rs
5V Out
The JLink allows powering the target device through [pin 19 of the 20-pin connector](https://www.segger.com/products/debug-probes/j-link/technology/interface-description/) or [pin 7 of the 10-pin connector (opposite of TDI)](https://github.com/gfroerli/hardware-v2/blob/master/datasheets/ARM-JTAG-20-10_latest-schematic.pdf) (at least on the Olimex adapter....
Would it be possible to create some releases in Github, containing the rendered schematics and gerbers? I think this would more easily allow people to track the revisions of the...
I'm not sure if this is possible over the shared USB port, but: When debugging a device with UART output, it would be fantastic if the hs-probe could also be...
Very cool design! You should consider using the [DAPLink](https://github.com/ARMmbed/DAPLink) firmware. We don't yet support the F723, but it's been on the requested and we'd happily accept contributions. Other work is...
If the target core is supplied with a voltage other than 3.3V, driving a signal line high will forward-bias the target pins esd diode, which may be destructive. Segger solves...
