pnp-feeder

pnp-feeder copied to clipboard

Where are the source files?

2

Is this a closed source project?

noeldum

I found with my printer the ratchet wheel the inner teeth were too rounded and I tended to have 1-2 teeth where the ratchet would not catch to continue driving...

Dloranger

I found springs on amazon that met the design specifications, but I am finding they are too weak to ensure a proper ratchetting. Can you either provide a source for...

Dloranger

just to make it all uniform and error free for other users besides those of us running the 3d printer side

Dloranger

I have had problems getting the springs to sit in place so I have made a small keeper to glue in the holes at each end which has solved my...

rharrison

I see you run a grey and black color schema, curious if this is necessary, or if it was an arbitrary decision? I understand the value in keeping the two...

Dloranger

Not sure what you're setup is, but I have my PNP on a plywood table and need a way to permanently affix the base plate to the table. Sure tape...

Dloranger

Please establish a standard direction for the magnets!

2

I encourage you to set some standard for which way the magnets are oriented. This way multiple people who use these feeders can easily share them with each other.

gwideman