Error: invalid subcommand "write_image erase "

[CHTUZKI]

Verbose mode can be enabled via -v, --verbose option CONFIGURATION: https://docs.platformio.org/page/boards/atmelsam/dueUSB.html PLATFORM: Atmel SAM 4.0.0 > Arduino Due (USB Native Port) HARDWARE: AT91SAM3X8E 84MHz, 96KB RAM, 512KB Flash DEBUG: Current (stlink) External (atmel-ice, blackmagic, jlink, stlink) PACKAGES: toolchain-gccarmnoneeabi 1.70201.0 (7.2.1), framework-arduinosam 4.4.191002, tool-openocd 2.1000.190707 (10.0) LDF: Library Dependency Finder -> http://bit.ly/configure-pio-ldf LDF Modes: Finder ~ chain, Compatibility ~ soft Found 3 compatible libraries Scanning dependencies...
No dependencies Building in release mode Checking size .pio\build\dueUSB\firmware.elf Advanced Memory Usage is available via "PlatformIO Home > Project Inspect" DATA: [ ] 2.6% (used 2576 bytes from 98304 bytes)
PROGRAM: [ ] 2.0% (used 10536 bytes from 524288 bytes) Configuring upload protocol... AVAILABLE: atmel-ice, blackmagic, jlink, sam-ba, stlink CURRENT: upload_protocol = stlink Uploading .pio\build\dueUSB\firmware.bin xPack OpenOCD, 64-bit Open On-Chip Debugger 0.10.0+dev (2019-07-17-11:28) Licensed under GNU GPL v2 For bug reports, read http://openocd.org/doc/doxygen/bugs.html debug_level: 1

0x2ba01477 target halted due to debug-request, current mode: Thread xPSR: 0x01000000 pc: 0x00080be8 msp: 0x20088000 ** Programming Started ** flash flash bank bank_id driver_name base_address size_bytes chip_width_bytes bus_width_bytes target [driver_options ...] flash banks flash init flash list gdb_flash_program ('enable'|'disable') mflash mflash bank soc_type base_addr pin_id target mflash init nand program [address] [verify] [reset] [exit] Error: invalid subcommand "write_image erase .pio\build\dueUSB\firmware.bin" embedded:startup.tcl:449: Error: ** Programming Failed ** in procedure 'program' in procedure 'program_error' called at file "embedded:startup.tcl", line 508 at file "embedded:startup.tcl", line 449 *** [upload] Error 1

[valeros]

Hi @CHTUZKI ! Looks like these commands write_image erase are specific for the project? Could you please provide more details?

[fdinardo-unsam]

I have the same error... Could you solve this error? Thanks