Thomas D.

@tobiasfalk How would you define minimum and maximum thickness?

I still don’t get what the use case would be. Thickness analysis would be great though, with the part colored like in FEM to indicate thickness below every point of...

I think I got it. There are two kind of thicknesses: 1. normal thickness, that is measured by the length of the segment normal to the surface at the selected...

Inertia should be part of this as well. In other software it is displayed alongside the mass, which is good because they are closely tied together. The most basic implementation...

@maxwxyz done with #13719. I mentioned the center of gravity. Not sure if it belongs here or there.

@PaddleStroke Arrows pointing in an area should end by a bullet by default. Pointed arrows are only for lines and points.

@PaddleStroke This is standard drawing practice, not UI/UX. In *Guide du dessinateur industriel* (A. Chevalier), there is the following example in the common mistakes section. TechDraw already has an acceptable...

@FEA-eng I think it should show the distance at the selected point. This kind of dimension shouldn’t be used for variable thicknesses anyway. It could change value when the point...

Who knows links very well besides @realthunder?

@realthunder What do you think about these issues?