phil2sat

Had this issue also (0x80073CF9), just removed Android subsysten i previously installed via Store and Amazon appstore, after unistall installation was possible without issues

try option noscan '1' or in luci force 40mhz also remove any beacon options or in luci delete input in, beacon interval, field, so that it defaults back to 100...

means both mesh devices need to be set on a wifi channel, not one eg. on 36 and the second to auto. both needs to be on channel 36

Did you try PA as country? normally it should be possible to set 30dbi if hardware is able to, if yes you can patch a wireless-regdb

So then youre not capped by the regdb, its either the chipset does max 27dbm or some antenna gain like 3dbi you could ty: "iw phy "$phy" set antenna_gain 0"...

?? openwrt uses opkg install, same as, dpkg -i for the make no target refer to..., [https://openwrt.org/docs/guide-developer/toolchain/use-buildsystem](url) maybe you need, make menuconfig, to select options for make to tell him...

Same for me, relatively new to all the stuff. To explain gpt4all uses llama ggml q4_0 models in a single bin file. Like: [wizardlm-13b-v1.1-superhot-8k.ggmlv3.q4_0.bin](https://huggingface.co/TheBloke/WizardLM-13B-V1-1-SuperHOT-8K-GGML) So we need a way to...

 Yes this tripled the FPS (9-11) as you can see in the picture, but still using only 12% cpu ressources. I dont know that are good...

So since the Amlogic is quite similar to the Pi4 this could be the first approach to get it running. I can run a Full Amiga 1200 68040 with MMU...

Just for your info, my i7-4790k with R290x using Vulkan, from 2014 is running martypc at full 60fps. (Just tested) I know martypc is new and its more than cool...