TAPO P100 stuck in installation limbo

[Netesfiu]

I've noticed that my TAPO P100 contoller never finishes installing. Re-integrating the device is possible, but update sensor remains the same state(see picture). The buttons are disabled and the update never actually finishes. The device is fully functional and has access to the internet as far as I'm aware. Only inconvinience that the update panel is now permanently populated with the device's update alert.

Home assistant information

#	version
Hardware	rpi4-64
os type	HASS-OS
Core	2024.4.3
Supervisor	2024.04.0
Operating System	12.2
UI	20240404.2

TAPO device info:

#	version
Firmware	1.4.10
Firmware available	1.5.5 Build 20230927 rel.40646
Hardware	1.20.0