satip-axe
satip-axe copied to clipboard
perexg
NO NETWORK
DIGIBIT R1
WHEN booting stock firmware no network (and device gets in a loop) WHEN booting with usb and idl4k.recovery device boots stock firmware OK
When booting with USB and using satip.exe.fwxxx NO NETWORK Knight Rider Effect OK
What's going ON ???
Sounds like something is wrong with your network, or maybe you're expecting it to get a specific IP address but it's getting some other address?
Well, if you can't get the stock firmware to work then I don't think you'll get any custom firmware working either.
Well, if you can't get the stock firmware to work then I don't think you'll get any custom firmware working either.
It boot in stock firmware, when I use idl4k.recovery on the USB ????
You can try my builds instead from here: https://github.com/Jalle19/satip-axe/releases/tag/build25, although I have a feeling it won't help.
Interesting, I have the same hardware and I have started to see a lot of errors at the ethernet interface on the LAN hub. if you have access to the counters at this level it may be worth a look.
You can try my builds instead from here: https://github.com/Jalle19/satip-axe/releases/tag/build25, although I have a feeling it won't help.
This morning booted with with recovery on USB Then installed your latest FW directly in de webmin And it booted ok For now !!!
Has Been working OK for 3 Days Now it does the same thing ??? I guess it 's really broke what would be a good replacement ????
Hi, i have same issue. i using some older version of satipaxe.. I've found 2 workarounds.
- connect your digibit r1 directly to router( switch have issue, i've tried zyxel (not working with 1000mb port, and netgear - sometime is ip loading long time sometime need restart) with direct connection to router were these issues minimized for me.
- you can set port on switch/router to 100mbit and try it.
Updated after check: I am using this configuration:
- original dhcp+satipaxe static e.g. x.x.x.86 ..(configured in /etc/sysconfig/config )
sometime i have issue to but it is somehow working. (sometime take time for loading ip) I have turris omnia router - and this issue is only happening when digibit r1 is connected via switch. If I connect digibit r1 directly to router then is no network issue.
I've just updated to original dhcp+satipaxe dhcp with [Jalle19]build25 same behavior as original dhcp+satipaxe static e.g. x.x.x.86 after some time is network working.
You can also try diferent ethernet cable - this could be issue too - one my cable wasn't able to start network.
But still is best way to connect digibit r1 directly to my router.