Configure Starlink for IPv6

Requirements

• Hardware: Ubiquiti EdgeRouter X
• Must not be using the Starlink Router
  • Connect the Starlink power brick directly to the WAN port (ie. eth0) on your EdgeRouter X

Usage

• Copy the script under /config/scripts to the same directory on the device
• Copy the enable-starlink-ipv6.sh script to your home directory (ie. /home/ubnt)
• Execute the script

Verification

Run the following command:

show interfaces

Look for the switch0 interface, and make sure there's an IPv6 /64 prefix associated with it.

• IMPORTANT: If you're on Windows, make sure that IPv6 protocol is enabled on your network interface.