pars3cproton

> my money is on bad solder (or cracked printed circuit trace) on the board you are pressing and the rest of the MMU unit. By pressing you are bending...

> this is clearly mechanical in nature. Something you are bending with your fingers enable the power to reach the MMU (leds on). You could try to push in different...

Sure, here you go! You can find pics of both old and new cable + the pd board https://drive.google.com/drive/folders/1YdJ2uTDLopkkKX7Hkqpco7Au8qQre-0z On Wed, 24 Apr 2024 at 12:03, Massimo Castelli ***@***.***> wrote:...

Bending the pin slightly didn’t work. i can try resoldering the pin on the pd board, it’s just weird to me that 2 pd board of 2 different batches show...

I have 2 of every electronic component, so I can experiment :D i broke the housing of the pin on the sheep board (big one) and probably you were right,...

Not really, but it’s better. Keep fiddling with it now put it in a position where it boots half the time without touching anything 😅 On Fri, 26 Apr 2024...

What kind of sorcery is that?? It does work as you said, if I keep the cable plugged in I have 100% boot success! On Wed, 1 May 2024 at...

It would make sense, but the usb is just plugged in and not connected to anything, as the other user said. And I was able to pinpoint the fault to...

This is a very funny bug btw! On Wed, 1 May 2024 at 12:13, parsec proton ***@***.***> wrote: > It would make sense, but the usb is just plugged in...

One thing that is tickling me is that maybe the bootloader expect the MMU to react faster than it could and the usb plugged in might put a small delay...