gps-sdr-sim code not working with Nuand bladeRF 2.0

[satyak-gps]

While running script getting below error sudo bladeRF-cli -s bladerf.script [INFO @ host/libraries/libbladeRF/src/helpers/version.c:103] FPGA version (v0.15.3) is newer than entries in libbladeRF's compatibility table. Please update libbladeRF if problems arise.

For best results, it is not recommended to set both RX and TX to the same frequency. Instead, consider offsetting them by at least 1 MHz and mixing digitally.

For the above reason, 'set frequency ` is deprecated and scheduled for removal in future bladeRF-cli versions.

Please use 'set frequency rx' and 'set frequency tx' to configure channels individually.

RX1 Frequency: 2400000000 Hz (Range: [70000000, 6000000000]) RX2 Frequency: 2400000000 Hz (Range: [70000000, 6000000000]) TX1 Frequency: 2400000000 Hz (Range: [47000000, 6000000000]) TX2 Frequency: 2400000000 Hz (Range: [47000000, 6000000000])

RX1 Frequency: 455549998 Hz (Range: [70000000, 6000000000])

Setting RX1 sample rate - req: 40000000 0/1Hz, actual: 40000000 0/1Hz

RX1 Bandwidth: 2500000 Hz (Range: [200000, 56000000]) RX2 Bandwidth: 2500000 Hz (Range: [200000, 56000000]) TX1 Bandwidth: 2500000 Hz (Range: [200000, 56000000]) TX2 Bandwidth: 2500000 Hz (Range: [200000, 56000000])

Loopback mode: none

Setting TX1 overall gain to 60 dB Gain TX1 overall: 60 dB (Range: [-23.75, 66]) dsa: -90 dB (Range: [-89.75, 0])

Error (bladerf.script:7): File not found

here is the device config bladeRF-cli -i bladeRF-cli version: 1.8.0-git-unknown libbladeRF version: 2.4.1-git-unknown Firmware version: 2.4.0-git-a3d5c55f FPGA version: 0.14.0 (configured by USB host) bladeRF> info Board: Nuand bladeRF 2.0 (bladerf2) Serial #: bffdcbdb2c3642b8a174fe886496cc57 VCTCXO DAC calibration: 0x1e1d FPGA size: 301 KLE FPGA loaded: yes Flash size: 128 Mbit USB bus: 4 USB address: 2 USB speed: SuperSpeed Backend: libusb Instance: 0

[osqzss]

Please use 'set frequency tx' as the error message says.