oscgonfer

As of new Arduino SAMD Cores >= 1.8.12 (tested), there is a change that doesn't allow to compile this library. Below there is the outcome of the compilation of the...

Sometimes, it seems that even if we send the FRC calfactor: ``` SCK > monitor scd30 Time Miliseconds SCD30 CO2 2024-06-04T16:57:30Z 13 855 2024-06-04T16:57:30Z 13 855 2024-06-04T16:57:30Z 13 855 2024-06-04T16:57:30Z...

After recent firmware changes to move to a new library, the parsing of commands on the `control` interface has gone all awol. We need to review all the commands listed...

For a newly flashed device: ``` SCK > read co2 SCD30 CO2: 696 ppm SCK > control co2 SCD30 CO2: Wrong command!! Options: interval [2-1000 (seconds)] autocal [on/off] calfactor [400-2000...

Seems that there is some JSON parsing errors on some info messages. For instance, it shows at the API level as: ``` Invalid Unicode [04 22 2c 22 68] at...

Not always, but it happens that the `read` command does not return a value after the wait time... (could be because of the adaptative interval), but from a user perspective,...

- [ ] Improve a bit the tolerances on the outdoor screws - [ ] Improve the position where the M4 screw from the umbrella blocks the lid (make more...

Given the wide variety of possible configurations, we should consider a new way to calibrate temperature/humidity. Options: - More defines - Add control command - ..? Just dumping ideas here

The ESP update process fails because the firmware size file is too large. More info coming later.

Pending: - [ ] Proofreading - [ ] About page finalisation Missing images: - [ ] https://docs.smartcitizen.me/knowledge/soil-water/DO/Atlas_DO/#submerging-the-sensor-directly - [ ] https://docs.smartcitizen.me/knowledge/air/chemical/SGX_MICS/#sensor-calibration - [ ] https://docs.smartcitizen.me/knowledge/air/noise/