How to handle devices with 3 sensors attached? Maybe add a third sensor field to devices.sensor.community?

[linuxlurak]

trafficstars

Hi

I have a device with three sensors: SDS011, LAeq (noise, Lärm) and BME280 on a nodemsu running Feinstaubsensor FW NRZ-2020-129. It works flawlessly. on devices.sensor.community i am able to setup two types of sensors. An additional filed for a third sensor type would be great, what do you think?

Thanks for the great work you are doing!

[ricki-z]

Hello @linuxlurak , please send an email to tech (at) sensor.community with the chipID of your device and that we should add the third component. At the moment we need to do this manually. Unfortunately it's not done with only adding a third field.

[linuxlurak]

Hallo @ricki-z Mail sent, thanks!

[DeeKey]

@ricki-z is it still need to be done manually? If yes then it must be added to configuration manual of DNMS. If already automated then please close the issue.

[ricki-z]

@DeeKey At the moment it's still done manually. Someone is working on it but I can't tell you when it's working.

[DeeKey]

Added note to DNMS manual about the issue.

[RikDrabs]

This issue still lingers around in the DNMS manual. Is it resolved or not ? We are going to start rolling out the DNMS in Belgium.

We = Open Knowledge Belgium / Civic Lab Brussels / InfluencAir project (restarted) + Beweging.net / LUCHTPIJP project (never stopped since 2018)

[ricki-z]

@RikDrabs it is now possible to add the third component at initial registration. So the roll out should be possible. At the moment it's not possible to add a third component later, after the initial registration. This is work in progress.