Add sensors to existing configuration

[dupuysylvain]

Hello,

I have created a new config with 1 sensor.

i want to add news sensors to the configuration but i can't : when i want to edit, we can't add sensor.

So i think to remove and recreate but when i try to remove but :

so if i deleted, i can't recreate for that chip...

[pjgueno]

Add a new station or a new sensor on the station ? It is not the same at all... Read here in French: https://sensor.community/fr/sensors/airrohr#Configuration https://sensor.community/fr/sensors/airrohr#Enregistrement You probably have to access your sensor in the network.

or can't you see this button in devices.sensor.community ?

[dupuysylvain]

Add a new station or a new sensor on the station ? It is not the same at all... Read here in French: https://sensor.community/fr/sensors/airrohr#Configuration https://sensor.community/fr/sensors/airrohr#Enregistrement You probably have to access your sensor in the network.

or can't you see this button in devices.sensor.community ?

Hey, thank for your reply,

i see this button ("register new sensor") but this is not what i need.

I have a board register with 1 sensor :

and i need to add a SDS011 sensor. It's posible during a creation but no when modifying.

Do you have a solution ?

Thanks

[pjgueno]

OK I found the answer in our forum: https://forum.sensor.community/t/can-not-add-second-or-more-sensors-after-deleting-it-once/550/13

Please send an email with the chipID to tech (at) sensor.community. We will add the BME280 again manually. (This was mentioned in this thread more than one time).