Om Sheladia

I will be taking up this task, though a small meet before getting started would be helpful.

@Jamm02 Gone through the resources, and am coming to the college tomorrow since I do not have Walle at the moment and will update how it goes tomorrow

So, I tried running the self_balancing in 2 situations, 1: With ferrite core and the capacitors And the readings are:  2: Removed just the ferrite core And the readings...

@dhairyashah1 I was told just to reproduce the results first and then test it with the new motor driver.

@dhairyashah1 The kit available in SRA when I went was not in the best condition, so had to reassemble it again. Then even while testing the esp32 mounted on the...

 So, this was the output on obstructing the motors to a greater extent without the the core and the capacitor. @gautam-dev-maker Does it satisfy the reproduction of issue?

I was informed in person today to carry out the same thing on a breadboard i.e. without using the sra board.

@dhairyashah1 I had to try the same thing with DRV883 and I never said anything about plugging it into the existing slot directly, was gonna use jumpers. But there was...

@dhairyashah1 it was not my decision to do the current task on the breadboard. As far as solution is concerned, I did try to run by some solution but was...

The tool suggested by Omkar didn't seem to work on my system then, however if crossing of arrows is the only concern then I have found something else that can...