olijouve

It's alive ! ``` GrblHAL 1.1f ['$' or '$HELP' for help] [MSG:'$H'|'$X' to unlock] error:9 G-code locked out during alarm or jog state. error:18 [VER:1.1f.20211209:] [OPT:VNMSL,35,1024,3,0] Target buffer size found...

>  > > That seems to have done the trick. Thanks. Did you already have this prepared or was some of my rambling actually helpful? How do you get...

Thanks. M122 returns error:9 G-code locked out during alarm or jog state. It's very cold in my worshop where my CNC is, so for testing purpose i do my test...

M122 doesn't report expecting infos, but if i try a movement on X the motor moves ! M122 [MSG:Warning: Could not communicate with stepper driver!] ok ok Starting stream [MSG:Pgm...

The setup i've followed on my board is entirely describe here(with pictures): https://docs.v1engineering.com/electronics/skrpro/ My setup use Dual End Stops (with EXTRUDERS 0 and 1 ), so i do not use...

@Creepop, would you mind to share a picture of how you connected everything on your board ?

I flashed back to Marlin to see what Marlin M122 is returning: ``` M122 axis:pwm_scale/curr_scale/mech_load|flags|warncount X X2 Y Y2 Z Address 0 0 0 0 0 Enabled false false false...

Not sure if it could be helpfull: ``` M43 PIN: PA0 (A0) M42 P35 E0_DIR_PIN protected . X2_DIR_PIN protected PIN: PA1 (A1) M42 P36 SERVO0_PIN Input = 0 PIN: PA2...

@terjeio, yes $338=1 and $14=7 still have same error after reboot: $338 $338=1 ok $14 $14=7 ok M122 [MSG:Warning: Could not communicate with stepper driver!] ok

@Creepop, I just reconnected my board just like yours, removed Power VCC to USB(with jumper),remove the 2 jumpers between Z and E0, also 24V on motors and i tried your...