ohAnd
TFT-Display doesn't change back to normal after Inverter switch off via App
I was doing a switchoff from the inverter with the Hoymile app and then a switch on.
The TFT-display shows inverter off correctly when it was switched off thats fine. But after switch on the TFT-display doesn't update the display back to normal with power-display. In the webpage I see the hint that there was a switch off and the rest shows the normal things thats also ok.
But the TFT doesn't go back to normal. If this is wanted, I would prefer to go back to normal with mayby extra symbol that there was a switch off. And then a possibility for delete this message in the webpage.
What would be also good to have the possibility to restart the DTUgateway-Module. Or is there any but don't find it?
Inverter: HMS-800W-2T FW: V.1.03.09 HW: H00.04.00
That should normally not happen - is that reproducable on your site?
Means if inverter is switched on again the normal display should appear.
For restarting - it's currently only directly possible with serial connection per cmd. With a 'trick' you can pushing it also with web ui - every change via the advanced config triggering a reset ... ;-)
tried this same behaviour ... and sequence ...
yes for a certain time there is the showing of inverter off instead inverter is already running again ... (after switching off by hoymiles webapp and switch on again a few minutes later)
but after a few minutes (due to update time with the inverter messages and things around) the web display and also tft showing the normal display again ---
the inverter on/off sequence was "let's say" optimized for dtuGateway setting inverter on/off - handle different sources was until now not intended...
so can you please check, if it is really never come back or it maybe needs only "too long time".
it will help, to find out what could be a useful solution
after >30 min not switching back, then I changed brightness value via advanced config then it come back (like you said)