oerkel47

Just tried with a fresh install with only psucontrol as 3rd party plugin. Same behaviour. The behaviour is the same as if the printer was off. It uploads and selects...

I am using that option already and connecting works, just the print doesn't start. Does it start printing for you? Or only connect?

Oh Wow. It works with 10 seconds delay! With 8 seconds apparently the timing is off but good enough for connecting.

Hi. It doesn't do the trick unfortunately. Additionally the slicer will throw an error now: `HTTP 500: {"error":"The server encountered an internal error and was unable to complete your request....

Ah. This works! Nice. https://pastebin.com/DDpPpy8b

Sorry, you are right. Didn't reset the post on delay to zero. ..doesn't work. https://pastebin.com/wMWGT0Rk

5 seconds runs into timeout. 6 seconds works. Both cases are in the log. https://pastebin.com/FgvF5LaY On another note: I noticed that the symbol lags when using this feature now. PSUcontrol...

Afterall an entry in the FAQ/Wiki to adjust the delay timing until it works is probably a good enough solution. I just hit an edge case with the timing..

>But I think this could need a "disconnect on external power off" function too? I don't think this is possible, because PSU Control has no way of knowing that you...

I see. My printer behaves differently apparently. Octoprint will instantly go to "Offline after error" when I shut it off externally and it didn't bother me. You could try adding...