Mavic air always LED Battery ON and dron starts, when insert the battery

[nekropolis]

hi!

Always Battery indicator is displayed, can't switch - LED_DISPLAY: 1=On [LED] LED Display state Does not respond to power button

Сan anyone help? I will provide more information if needed.

      SYS_PRESENT_LOW:	0=Inactive	[PRES]	System present input state low
       DSG_FET_STATUS:	0=Inactive	[DSG]	Discharge FET status
       CHG_FET_STATUS:	0=Inactive	[CHG]	Charge FET Status
      PCHG_FET_STATUS:	0=Inactive	[PCHG]	Precharge FET Status
          FUSE_STATUS:	0=Inactive	[FUSE]	FUSE input status
      TRIP_POINT_INTR:	0=Inactive	[BTPI]	Battery Trip Point Interrupt
        SECURITY_MODE:	2=Unsealed	[SEC]	Security Mode
    SHUTDOWN_LOW_VOLT:	0=Inactive	[SDV]	Shutdown triggered via low pack voltage
        SAFETY_STATUS:	0=Inactive	[SS]	Safety mode status
    PERMANENT_FAILURE:	0=Inactive	[PF]	Permanent Failure mode status
 DISCHARGING_DISABLED:	1=Active	[XDSG]	Discharging Disabled
    CHARGING_DISABLED:	1=Active	[XCHG]	Charging Disabled
           SLEEP_MODE:	0=Inactive	[SLEEP]	Sleep mode condition met
       SHUTDOWN_BY_MA:	0=Inactive	[SDM]	Shutdown activated by SMBus command
          LED_DISPLAY:	1=On	[LED]	LED Display state
         AUTH_ONGOING:	1=Active	[AUTH]	Authentication ongoing
   AUTO_CC_OFFS_CALIB:	0=Cal Done	[ACALM]	Auto CC offset calibration by SMBus cmd
    RAW_ADC_CC_OUTPUT:	0=Inactive	[CALOC]	Raw ADC/CC data calibration output
    RAW_CCOFFS_OUTPUT:	0=Inactive	[CALOO]	Raw CC offset data calibration output
     XLOW_SPEED_STATE:	0=Inactive	[XL]	400 kHz transmission SMBus mode
          SLEEP_BY_MA:	0=Inactive	[SLEPM]	SLEEP mode activated by SMBus command
     INIT_AFTER_RESET:	0=Inactive	[INIT]	Initialization after full reset
       SMB_CAL_ON_LOW:	0=Not in Cal	[SLCAL]	Auto CC calibration when the bus is low
    ADC_MEAS_IN_SLEEP:	0=Inactive	[SLPAD]	ADC Measurement in SLEEP mode
     CC_MEAS_IN_SLEEP:	0=Inactive	[SLPCC]	Current Check measurement in SLEEP mode
       CELL_BALANCING:	0=Inactive	[CB]	Cell balancing status
   EMERGENCY_SHUTDOWN:	0=Inactive	[EMSHT]	Emergency Shutdown

after charging

       DSG_FET_STATUS:	1=Active	[DSG]	Discharge FET status
       CHG_FET_STATUS:	1=Active	[CHG]	Charge FET Status

and if insert the battery into the drone, it starts, but can't fly - battery not installed properly