Tado: 'Power' is an event - not an action

[simonseres]

The 'Power'-action is wrong and should actually only be an event.

I realised it when I tried to turn power on on a radiator -but a few seconds after, it turned off again. After repeating this, I realised that Tado only reacts on the target temperature - and switches on / off if lower or beyond that temperature.

So changing the Power action to an event would allow to see if it is currently heating or not. I would also rename it to heating (or 'heating up') - to make this status more obvious.

Turning it off or on is anyway possible by selecting the Mode: OFF / Tado / Manual

[mzanetti]

Read-only state, not event, but yes, makes sense otherwise.