nomadbyte

> ... Pedal was NOT recovered by re-flashing the FW. The fw installer apparently does not rewrite the flash memory content; not in the normal running mode, at least. It's...

> ...It can be a bit tricky to install pyalsa I went the Python3 route on the older Ubuntu 18.04; there's no `python3-pyalsa` available from the Ubuntu distro repo (unlike...

Update to `pyalsa-1.2.7`. Discussed earlier, see #10 and #7

I updated the aggregated ZDL modules list adding DSP-usage column (see #30). The values are derived from the corresponding DSP usage figure included in ZDL module (`OnOff` section) as `DSP_usage...

I tested a few ZDL effect combinations and it looks like the ZDL-based DSP usage percentage is used with 90% cut-off. That is adding an effect such that the patch...

Changing the visible effect cannot be done directly with a specific MIDI/Sysex command. The visible/focus effect setting can only be changed in the patch data. The whole updated patch then...

Assuming that this is needed for switching on/off the individual effects in the chain, this could be done directly with a Sysex: 31 for the given effect slot (for slot...

Changing which effect in the patch is currently visible on the screen cannot be done with a MIDI/Sysex command. The change has to be done in the patch data and...

You you're willing to tap the footswitch on the pedal, then you may just as well use the footswitch to turn on the TAP TEMPO mode with the __footswitch long...

> I am trying to decode a patch from G1Xon pedal (1.21 firmware)... Here it is: G1Xon:"Blue Lead":3:(Level:100): 1. DYN:"0x01000008.Comp":On:(0, 0, 0, 0, 0, 0, 0, 0, 0, 0) 2....