Nick

I will try again tomorrow with ZHA if it's easier then.

I have redone what you have asked for. Here is the output: `{ "ieee": "50:0b:91:40:00:04:9c:6d", "nwk": "0xe02e", "model": "DM2550ZB", "manufacturer": "Sinope Technologies", "manufacturer_id": "0x4508", "endpoints": [ { "id": 1, "device_type":...

I ran the scan after installing only zha and zha-toolkit. It was never connected to Neviweb. It's fresh out of the box with Home assistant only. In the manage ZigBee...

> For the SW2500ZB that you have scanned at the beginning did that devive was connected to neviweb before ? In the manage ZigBee device section you see the attribute...

I tried to play with this attribute:  I tried setting to 0 and 2. Both writes were successful but I didn't notice anything on my lights. I'm not really...

> When you put 0 or 2 for attribute 0x0001 when you read it back does the value change. This attribute is of type bool so I think you should...

Thanks for all your help. What I thought would be something simple looks like will be more complicated. I just wish Sinope would just provide this information instead of keeping...

It would be interesting to see if they also update the firmware after connecting to Neviweb. If you sniff that traffic, would you be able to also sniff the firmware...

Is the button to deactivate a pod still active? If yes use it. 

You didn't need to build the dev version to apply the hotfix. But if you want to run closed loop in Dev builds you need to enable engineering mode. Instructions...