netweaver1970

@PureDJ I'm also very interested in your own implementation. Right now I have a Migo (Bulex/Vaillant rebranded Netatmo smart thermostat), which has internet based outside temp supply, heating curve setup,...

> tried DEVEL works ok. Seems stable RPI 3b+ HA OS How are you running ebusd on HassOS? As a manual "docker run" (from within the terminal & SSH add-on)...

Thanks for the fixing and the testing! I'll upgrade when back home too

answering my own question on the input pin level shifting, it seems the GPIO pins are 5V tolerant but can sink only up to 20-25mA. so a 10K resistor in...

I decide to jump ahead. I did as I planned, soldered the MQ5 module's 5V supply line on the IN pin of the TS1117 and took GND and D7 from...

@John30 Now that the adapter is finally providing proper heater messages via mqtt, how can I get the state of the other wemos input pins, such as the gas/switch input?...

Sure, one can do it on multiple levels. I agree that the lowest level (aka Klipper) should have its own input validation but knowing how busy Kevin is and me...

Indeed, the editing is a bit awkward. But on other UserInput fields, there are also secondary/fail-safe checks on the ultimately entered values. Anything to make it safer, either by changing...

Out of interest, as I have a dockable probe (Mantis toolhead with Annex Quickdraw derivative) install coming up, what needs to be done to get this merged into the master?...

indeed, by retyping the dashes in the tuya-cli command line, the full command got understood. But now I have the next issue, the device is in pairing mode but the...