No show Available in a VLAN-group

[nomad-cyanide]

Deployment Type

Self-hosted

NetBox Version

3.6.9

Python Version

3.10

Steps to Reproduce

1. Under IPAM, click a VLAN-group with vlans 1 and 5 in it.
2. There should be a "4 available vlans" green button. There is none, making it much harder to see which vlans are available.

Expected Behavior

There should be a "4 available vlans" green button. There is none, making it much harder to see which vlans are available.

Observed Behavior

No showing of available vlans in a vlan-group

[sleepinggenius2]

I found out the hard way that it doesn't show those Available buttons if you have your table sorted at all. I would make sure that you clear any sorting and the buttons should come back, as expected.

[jeremystretch]

This is working as expected for me on v3.7.2. As @sleepinggenius2 points out, you might have an ordering or filtered applied to the table, which is preventing the annotation of available VLANs. Try resetting the table's configuration by clicking the "configure table" button at top right, then "reset."

2. There should be a "4 available vlans" green button.

Not to be pedantic, but just for clarity, it should read "3 VLANs available" as above.

[nomad-cyanide]

I works as you are all describing. It was a stressful situation, with multiple actors wanting things done, so I forgot to sit back to think and just rushed a bug-report, to get them off my back. My sincere apologies!