ncpe20012003

With the RS panel in Auto mode, not service mode, AqualinkD does not activate the heater. For testing purposes, it does toggle the filter pump. On Fri, Mar 6, 2020,...

> It sounds like you need to configure the control panel for the heater. If you don’t have a RS keypad to do that from, you can use AqualinkD in...

The newer Jandy equipment have RS485 onboard. Seems like AqualinkD should be able to utilize it instead of panel. On Fri, Feb 7, 2020, 1:02 PM sfeakes wrote: > No,...

New pool just installed. I have Jandy JXi Heater and a Jandy VersaFlo Variable Speed pump. On the pump, the contractor installed an IQPUMP01 Jandy Pro Series VS Mobile Pump...

Okay, I broke down and purchased a Jandy RS 8 P&S on ebay with Rev Q PCB. I'm able to communicate to it via AqualinkD/Raspberry Pi/RS485. I can enable/disable buttons...

See attached, 0x68 is the heater. On Sun, Feb 23, 2020 at 8:03 PM sfeakes wrote: > When installed correctly, your iAqualink interface should be able to talk > directly...

Page 28 of the JXi manual indicates that Rev N and above should work, I'm at Q. https://www.jandy.com/-/media/zodiac/global/downloads/h/h0574300.pdf Reading the last bullet for Rev N in the pdf you sent...

After additional testing yesterday, I found that rev Q does control the JXi heater. What i was missing was water temp input on the RS panel. I put a 22k...

Any advice on this? On Sun, Mar 1, 2020, 10:25 AM Chad Hoyle wrote: > After additional testing yesterday, I found that rev Q does control the > JXi heater....

Once the JXi is connected to the RS8 panel via 485 is automatically goes into Jandy Remote mode. On Fri, Mar 6, 2020, 4:28 PM Tim Elery wrote: > I...