pause at height - fails if added more that once

[peetersmark]

For one pause at a single given Z this works fine, but if you need a 2nd or 3rd pause at another Z it fails. if you try to add this plugin 2 or more times it fails by executing all the pauses to the same Z in the gcode and usually it not even close to any of the Z values asked for. It's been this way for years, maybe a note in the tool tips warning against multiple uses would be nice.

[nallath]

I will have a look at it tonight. Remind me again later on in case I forget.

[peetersmark]

thanks. I've been adding my own by hand since the plugin gets crazy if you ask it for more that one pause.

[JPFrancoia]

Hum, I managed to use it with several pauses (more or less, this plugin is buggy anyway). It "works" with cura 2.5 beta.

I think you need to insert the pauses by descending order of height. Ex:

• Pause at 150 mm
• Pause at 130 mm
• Pause at 120 mm

Did you try that ?

Also, with cura 2.5, you can load the gcode and see the travel path of the nozzle. You can check that the pauses are really there.

[peetersmark]

I think I had added them low to high pause 0.5mm pause 0.7mm pause 1.7mm pause 1.9mm

I'll try to find a machine to put beta since this will screw up my normal machine due to 2.x intolerance of other cura's.