Possibly cooked LimeSDR-USB

[wighthat]

Hi myriadrf,

I think I may have killed a Lime by failing to connect a fan while leaving it running. LimeQuickTest shows the board as failed. Can you confirm that the below output would indicate a dead board, please? Also, if there’s a better place to ask this kind of question can you please point me in the right direction?

Thanks

Mike

sbc002:~$ LimeQuickTest [ TESTING STARTED ] ->Start time: Fri Oct 25 12:44:11 2019

->Device: LimeSDR-USB, media=USB 3.0, module=FX3, addr=1d50:6108, serial=0009072C00D52D1D Serial Number: 0009072C00D52D1D

[ Clock Network Test ] ->FX3 GPIF clock test Test results: 31171; 34927; 38683 - PASSED ->Si5351C test CLK0: 17554 / 17554 - PASSED CLK1: 17554 / 17554 - PASSED CLK2: 17554 / 17554 - PASSED CLK3: 17554 / 17554 - PASSED CLK4: 17554 / 17554 - PASSED CLK5: 17554 / 17554 - PASSED CLK6: 17554 / 17554 - PASSED ->ADF4002 Test Result: 10 - PASSED ->VCTCXO test Results : 5112924 (min); 5113070 (max) - PASSED ->Clock Network Test PASSED

[ FPGA EEPROM Test ] ->Read EEPROM ->Read data: 12 0C 06 12 0C 06 02 ->FPGA EEPROM Test PASSED

[ LMS7002M Test ] ->Perform Registers Test ->External Reset line test Reg 0x20: Write value 0xFFFD, Read value 0xFFFD Reg 0x20: value after reset 0x0FFFF ->LMS7002M Test PASSED

[ RF Loopback Test ] Note: The test should be run without anything connected to RF ports ->Configure LMS ->Run Tests (TX_2-> LNA_L): SetFrequencySXR(800 MHz) - cannot deliver frequency ->Run Tests (TX_1 -> LNA_W): SetFrequencySXR(1800 MHz) - cannot deliver frequency ->Run Tests (TX_2-> LNA_H): SetFrequencySXR(2500 MHz) - cannot deliver frequency ->RF Loopback Test FAILED

=> Board tests FAILED <=

Elapsed time: 1.52 seconds

[Jelly478558074]

LimeSDR USB，What is the name of the transmitting antenna?