[BUG] The configured monitors are turned off after restart PC

[IvanIsak2000]

The configured monitors are turned off after restart PC

I have two additional hdmi monitors that are connected to the main Lenovo ThinkPad laptop.

Before that, I had been using arch linux for about 2 years and the monitors worked fine.

recently, I decided to try hyprland and installed hyprland ml4w.

Initially, my monitors were not positioned correctly, so I began to look at the documentation and added the following lines to monitor.conf, as I remember: the left monitor with a resolution of 1920x1080 and at the end 1, also for the right monitor, but with an offset location, and finally the third line for the built-in monitor: name and disable.

After typed the hyprctl reload command, and all the monitors correctly fell into their intended places, that is, the additional monitors work, but the built-in one does not.

Everything worked fine all day, the PC went into sleep mode many times, but after logging into the profile everything was reborn correctly!

In the evening, I decided to restart the PC, but after entering the password for the profile, those monitors that were supposed to work did not work, it was written on them that there was no signal.

At the same time, the power button was flashing as if the PC was in sleep mode, although I was logged in.

And accordingly, now I can't go anywhere beyond authorization. The video with the error is below: https://jmp.sh/s/OeLelb71tdj1wNBb0Htj

Distribution (please complete the following information):

• Arch Linux

Is this my problem with the config? But if I didn't configure the monitor correctly, the system would crash immediately, wouldn't it?