Mudit Agrawal

Is there anyway we could utilize the Duke Makerspace for this? I'd be more than happy to print a couple of enclosures and keep them as inventory and ship out...

I can print as much as I want for free as well if that's helpful

I was thinking that we should put them onto the back of the enclosure right below the shroud head, but I want to do some experimenting to see where these...

@eaudiffred sounds good! I will add some to the thread right now

This was one I created, could be attached easily to the back and allow to hook on to a pipe or fencing material

This is another one, basically similar to the last one except would span the entire width of the back of the enclosure

This one would be a variable one where you could slide the two ends across the channel to fit across any component of varying length

I created it on the shroud but the ideal location would be on the back of the enclosure

These are more simple hooks, but im working on a design right now to make the bottom hook slideable through a channel