gravitymon
gravitymon copied to clipboard
mp-se
iSpindle replacement firmware for beer brewing/fermenting
**Is your feature request related to a problem? Please describe.** The gyro uses a lot more energy than the DS18B20 temperature sensor. For applications where you want to use the...
Hello, I would like to configure my iSpindle to send information to CraftBeerPi 4. I saw that currently there are only instructions for BrewBlox. Could you provide similar instructions for...
Investigate wifi connection behaviour. Some sources point to that the esp will connect to the last wifi ap and not the strongest if multiple ap with the same name exist....
It would be good to have proper validation of SSL certificates. Uploading all current CA is not an option, it takes to long to load them from disk ~3 seconds....
Wrong PIN definitions in Arduino/esp32 framework. See: https://github.com/espressif/arduino-esp32/issues/9037
On the latest arduino version Wire returns [Wire.cpp:513] requestFrom(): i2cRead returned Error 263 https://github.com/espressif/arduino-esp32/issues/8056 Will test with v3.0 when platformio has added support
**Describe the bug** The UI reports no temperature sensor detected after upgrading from 2.0.0-beta2 to 2.0.0-beta3 **To Reproduce** Steps to reproduce the behavior: 1. flash 2.0.0-beta3 2. observe the error...
**Describe the bug** Exception happens after movement detected. MQTT for Home Assistant and HTTP for Brewfather configured. **To Reproduce** Steps to reproduce the behavior: 1. Have gravitymon on 2. Move...
Describe the bug The system fails to detect the temperature and gravity sensors after flashing iSpindel. This issue occurs on both version 2.1.0 and 2.0.0. The development board used is...
