Unable to flash coral dev board with Yocto Zeus(Flashing problem)

[alphaanyms05]

I built a Yocto Zeus image successfully. Now, I am flashing coral board using the SD card flashing method. I am getting the following errors:

Console Logs:

U-Boot SPL 2017.03.4-release-day+g8523a101cd (May 12 2021 - 13:22:06) power_bd71837_init pmic debug: name=BD71837 Board id: 0 start to config phy: p0=3200mts, p1=667mts with 1D2D training check ddr4_pmu_train_imem code check ddr4_pmu_train_imem code pass check ddr4_pmu_train_dmem code check ddr4_pmu_train_dmem code pass config to do 3200 1d training. Training PASS check ddr4_pmu_train_imem code check ddr4_pmu_train_imem code pass check ddr4_pmu_train_dmem code check ddr4_pmu_train_dmem code pass config to do 3200 2d training. Training PASS check ddr4_pmu_train_imem code check ddr4_pmu_train_imem code pass check ddr4_pmu_train_dmem code check ddr4_pmu_train_dmem code pass pstate=1: set dfi clk done done Training PASS Load 201711 PIE Normal Boot Trying to boot from MMC2 hdr read sector 300, count=1

U-Boot 2017.03.4-release-day+g8523a101cd (May 12 2021 - 13:22:06 +0000)

CPU: Freescale i.MX8MQ rev2.1 1500 MHz (running at 1000 MHz) CPU: Commercial temperature grade (0C to 95C) at 40C Reset cause: POR Model: Freescale i.MX8MQ Phanbell DRAM: 3 GiB Board id: 0 Baseboard id: 1 MMC: FSL_SDHC: 0, FSL_SDHC: 1 *** Warning - bad CRC, using default environment

In: serial Out: serial Err: serial

BuildInfo:

ATF 1cb68fa U-Boot 2017.03.4-release-day+g8523a101cd flash target is MMC:0 Net: Warning: ethernet@30be0000 using MAC address from ROM eth0: ethernet@30be0000

Has anyone faced the same problem? Help me